Before you begin splicing wire, it will be helpful for you to take note the locations of all splices for future reference. If you ever have a wire break, these most often happen at a splice and it will be helpful to you to be able to find your splices easily if this ever happens.
To make a splice:
Note: If your splice pulls loose, the system will not function. Make sure your splice is secure.
Lightning strikes, even miles away, can create powerful surges or spikes which may damage your electronic in-ground fence. In nearly every case, damage to the transmitter results from power surges or spikes traveling through the Boundary Wire and not the power adapter.
Plug unit directly into the wall outlet, then plug your transmitter into the convenient piggyback outlet. A few simple wiring connections and installation is done; includes complete instructions. Inexpensive surge protectors will not protect the transmitter because they do not contain protection for the Boundary Wire. See operating guide for safety information. This device is a UL or ETL listed transient voltage surge suppressor. Replaces RFA-28 (discontinued).
Includes long and short/standard contact points plus replacement pieces for your pet's fence receiver collar. The washers are used to keep the receiver attached to the strap. The protective clear caps help to keep water and debris out of the switch port on receivers with correction level adjustment buttons. The 4 screws can be used to replace the receiver screws on Stubborn Dog receivers.
Rubber base "gives" while the stainless steel tip maintains contact with your dog's skin. Greater wearing comfort with the same effectiveness as traditional PetSafe®️ contacts. Receiver collars sold separately.
Use with PetSafe®️ Remote Training and Fencing products. Not for use with Bark Control Collars.
Gentle spring action makes your dog fence safer and more comfortable too! Great for dogs with any type of coat!
Fits most dog fence collars that accept a screw-in contact post.
Can be used with all Perimeter Technologies®️ Systems, PetSafe®️ PIF-300 and PetSafe®️ PIF-275-19.
Gentle spring action makes your dog fence safer and more comfortable too! Great for dogs with a thick coat where contact is difficult to achieve. Fits most dog fence collars that have 6/32" male threads protruding from the receiver collar. Can be used with all YardMax®️-Pro Receivers.
Gentle spring action makes your dog fence safer and more comfortable too!
Great for all dogs where contact may be difficult to achieve.
Fits most dog fence collars that have 6/32" male threads protruding from the receiver collar.
Can be used with all YardMax®️-Pro Receivers.
Test light for most remote trainer, bark, and fencing receiver collars with static correction. Included in many kits, this tool is also designed as a wrench to tighten contact points and has a tab to easily remove most batteries and battery covers.
The Test Light Tool is used to tell if your collar is working properly. Hold the tool against the contact points and activate the collar. For a remote trainer, activate the correction using the transmitter. For a fence, move the collar near the boundary, holding the collar at your dog's neck height. The tool will light up if the collar is activating.